Atec Agilent-N8300A - Manual (Page 7)

7
Rear panel (continued)
SOURCE TRIG IN Accepts TTL and CMOS level signals for
triggering point-to-point in sweep mode.
Damage levels are ≤ –0.3 V and ≥ +5.3 V
SOURCE TRIG OUT Outputs a TTL- and CMOS-compatible signal
level for use with sweep mode. Input
damage levels are ≤ –0.3 V and ≥ +5.3 V
ANALYZER TRIG IN
Connector BNC female
Impedance > 10 kΩ nominal
Trigger level range –5 to +5 V
ANALYZER TRIG OUT
Connector BNC female
Impedance 50 Ω nominal
Level 5 V TTL nominal
Monitor output
Connector VGA compatible, 15-pin mini D-SUB
Format XGA (60 Hz vertical sync rates, non-
interlaced)
analog RGB
Resolution 1024 x 768
USB 2.0 ports
Master (4 ports) Note: One port is permanently connected;
three ports are available for use
Standard Compatible with USB 2.0
Connector USB Type-A female
Output current 0.5 A nominal
Slave (1 port)
Standard Compatible with USB 2.0
Connector USB Type-B female
Output current 0.5 A nominal
GPIB interface
Connector IEEE-488 bus connector
GPIB codes SH1, AH1, T6, SR1, PP0, DC1, C1, C2, C3,
C28, DT1, L4, C0
LAN TCP/IP interface Connector located middle of rear panel
Standard 100 Base-T
Connector RJ45 Ethertwist
LAN
Connector located bottom right hand side of
rear panel
Standard 100 Base-T
Connector RJ45 Ethertwist