Atec Anritsu-S820E - Manual (Page 2)

2 of 16 PN: 11410-00749 Rev. A S820E TDS
Specifications Site Master™ S820E
Description Page
Definitions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Cable and Antenna Analyzer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
High Accuracy Power Meter – Standard . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
General Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Line Sweep Tools™ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Ordering Information – Standard Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Frequency Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Measurement Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
USB Power Sensors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
USB Transmission Sensors and USB Extender Kit . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Documentation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Standard Accessories. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Optional Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Definitions
All specifications and characteristics apply under the following conditions, unless otherwise stated:
Warm-Up Time After 10 minutes of warm-up time, where the instrument is left in the ON state.
Temperature Range Over the 23 °C ± 5 °C temperature range.
Reference Signal When using internal reference signal.
Typical Performance Typical specifications that are not in parenthesis are not tested and not warranted. They are generally
representative of characteristic performance.
Typical specifications in parenthesis () represent the mean value of measured units and do not include any
guard-bands or uncertainties. They are not warranted.
Uncertainty A coverage factor of x1 is applied to the measurement uncertainties to facilitate comparison with other
industry handheld analyzers.
Calibration Cycle Calibration is within the recommended 12 month period (residual specifications also require calibration kit
calibration cycle adherence.)
All specifications subject to change without notice. For the most current data sheet, please visit the Anritsu
web site: www.anritsu.com