Alpha Technologies Micro Secure UPS - Manual (Page 33)

31
017-220-J0 Rev B
6.4.10 100-Event Log
Up to 100 events are stored in the Alpha Micro Secure’s log. If more than 100 events occur, the oldest is over-
written.
Procedure
1. To see the log, type event (all lower case) and press Enter. The events are listed starting with the most
recent and appear as: If less than 100 events occurred, the last entry will appear as:
See below for details on these
readouts.
eventX=12/25/99 01:45:59 0000000000000000, 0000000000000000, 000
Event Date Time Alarm Fault Mode
Date & Time formats depend
on selected display format
Alarm: When the following bits show a 1,
the following alarms are displayed.
Self Test
Fault: When the following bits show a 1,
the following faults are displayed..
Table L — Event Codes
Code Mode Code Mode Code Mode
000 Standby 003 Boost 1 006 Inverter
001 Line 004 Buck 1 009 Shutdown
002 Boost 2 005 Buck 2 010 Bypass
2. If less than 100 events occurred, the last entry will appear as:
3. To clear the log, type eventclr and press Enter. It takes the Alpha Micro Secure 30 seconds to clear the log.
Do not enter any other commands during this time.
4. To see a specific event, type eventX where X is from 1 to 100 and press Enter. To see a range of events (for
example, events 20 to 30), type eventX-X where X are events from 1 to 100 and press Enter.
eventX=00/00/00 00:00:00 0000000000000000, 0000000000000000, 000