Alpha Technologies Micro Secure UPS - Manual (Page 14)

017-220-J0 Rev B
12
5. Installation
Once the installation location has been planned and prepared, you are ready to install the Alpha Micro Secure.
There are three steps to setting up the Alpha Micro Secure:
1. Mounting the Alpha Micro Secure
2. Wiring the Alpha Micro Secure
3. Installing and wiring the external batteries
5.1 Transporting and Lifting
WARNING!
To avoid personal injury or damage to the equipment, always use at least two installa-
tion personnel to remove the unit from its container.
Batteries must not be installed until the Alpha Micro Secure enclosure has been secure-
ly set in place at its permanent location. Transporting the unit with batteries installed
may cause a short circuit, fire, explosion, and/or damage to the battery pack, enclosure
and installed equipment. Damage caused by improper shipping or transporting a unit
with batteries installed is not covered by the warranty.
5.2 Mounting Options
Choose any of the following four mounting options:
• Mounting to a wall
• Mounting to a wooden pole
• Mounting to a steel/concrete pole