Alpha Technologies CFR 600, CFR 600XT, CFR 1000 - Manual (Page 39)

33
3
5.7 Output Parameters
“OUTPUT PARAMETERS” provides UPS Output Voltage, Current, Volt
Amps, Power in Watts, Power Factor, and Line Frequency information.
OUTPUT #1
Voltage
The RMS voltage measured at the output of the UPS (i.e., 120 VAC).
Current
The flow of current measured at the output of the UPS (i.e., 3.1 Amps).
OUTPUT #2
Voltage
Not available on this unit and should read ‘0’.
Current
Not available on this unit and should read ‘0’.
Volt Amps
The apparent output power of the UPS calculated by multiplying output
voltage by the output current (i.e., 663 VA).
Power in Watts
The true output power of the UPS calculated in Watts (i.e., 600 Watts).
Power Factor
The ratio of true power (power actually consumed) to apparent power
(simple product of voltage and current) at the output of the UPS (i.e., 0.89).
Line Frequency
The frequency of the AC Line measured at the output of the UPS
(i.e., 60.0 HZ).
5. RS-232 TERMINAL COMMUNICATION