Alpha Technologies AlphaGen PN-6x-T 7.5kW 48VDC - Technical Manual - Manual (Page 53)

042-288-B0-001, Rev. A 53
3.0 Installation, continued
3.16 Final Inspection Checklist
Set the ECM Run/Auto/Stop (RAS) switch to the STOP position before initially powering up the
ECM. This allows the operator to manually control the START and STOP functions of the APU until
the system is set up. This also prevents the APU from starting unexpectedly.
CAUTION!
Once the installation is complete, verify the following:
1. Engine oil at proper level
2. All electrical connections securely made
3. Engine Control Module (ECM) set to STOP
4. Battery connections made
5. Battery voltage normal.
6. Gas connections checked for leak integrity
7. Gas pressure normal
When the above checks are complete, the unit is ready for initial turn-up.