ABUS TVIP72000 - Manual (Page 40)

40
4.3 Aligning the camera module
Loosen one of the two screws to the left or right of
the camera module (see diagram on right, item 7).
Use the tool provided to do this (hexagon wrench).
You can now align the spherical camera module
vertically and (slightly) horizontally by inserting the
tool in the opening on the top of the camera module
(see diagram on right, item 8).
Retighten the fixing screw.
4.4 Description of the status LEDs
LED State Description
P – LED for displaying the
operating voltage Constantly red Power supply active
S & L – Network status
S lights up orange, L flashes green
(at irregular intervals) Network status is OK, IP assigned
correctly
S & L – Network status Both LEDs inactive Disconnected from network
4.5 Description of the reset button function
Function Description
To reset the camera to factory settings, press the
reset button on the camera. Then disconnect the
power supply to the camera but still hold the reset
button.
Now reconnect the power supply.
After 10 seconds release the reset button.
Now the camera is reseted to factory defaults.
Camera reset to the factory settings.
7
5
6
8
7