ABUS FU8321 Secvest 2WAY Wireless Magnetic Contact Detector (FSL) - Manual (Page 15)

Important!
10. Attaching the detector
Do not attach on or near metal surfaces!
Do not attach within 1 metre of gas, water or power lines!
Do not attach near electronic devices (e.g. computers,
photocopiers or other detectors)!
11. Range
The range is dependent on the surrounding conditions. Therefore, use
double-sided adhesive tape to fix the detector temporarily in different
locations and test it by triggering an alarm. If this signal is not detected by the
Secvest, move the detector to a new position. The signal strength should not
fall below 3. Testing using the Secvest: Installer menu  Test  Detector
signal
12. Installation location
The best place to install the wireless opening detector is the upper corner of
the window/door frame. Ensure that the detector is installed on a flat surface
so the TS2 contact switches correctly (see “Training zone 1”).
Displays : Secvest
!
GB