Cla-Val X143IP - Manual (Page 3)

• Close the isolation valve in the bypass to stop the turbine
• Remove the removable terminal block with Terminals 1 to 10 (see page 2, Figure 3)
• Remove the solenoid connector using a screwdriver (see Figure 5)
• Switch the solenoid with a 9 Volt 6LR61 battery as shown (see Figure 6)
• Open the isolation valve on the bypass to engage the turbine
• Measure the AC voltage of the turbine as shown (see Figure 7)
• See page 4, Figure 8 for proper oeprational parameters
X143IP Intermediate Power Generator
Quick Start Instructions
Start-Up Instructions
• Once the electrical connection is complete, connect the battery:
• Red cable to Terminal +
• Blue cable to Terminal -
• Open the isolation valve on the bypass directly after connecting the battery.
• The turbine will start to run and the differential pressure controller will
start to regulate
• Check that the LED inside the Control Box flashes either red or green (see Figure 4).
• The first minute is a starting cycle where the solenoid discharges to
atmosphere two times
• Check that the X143IP Power Generator is powering the desired electronic devices
• Close the electrical box with the six screws provided
• The X143IP Intermediate Power Generator is commissioned and ready to be used
Measuring differential pressure across the turbine
Figure 4: LED
Figure 5: Solenoid Connector Figure 6: Battery Connection
Pole -
Pole +
888.8
OFF
V A
COM A
Figure 7: Measuring AC Voltage
3
WARNING
High AC
Voltage
Use extreme caution
when operating the
X143IP with Control
Box cover open