Cla-Val X143IP - Manual

X143IP Power Generator Retrofit Kit
The pre-assembled X143IP Intermediate Power Generator
Retrofit Kit contains the following component assemblies,
and is shipped ready to mount on a Cla-Val Automatic
Control Valve.
• X143IP Power Generator
• 3/4-inch inlet piping assembly
• 3/4-inch outlet piping assembly
X143IP Intermediate Power Generator
Quick Start Instructions
for technical assistance, call
800.942.6326 or log-on to
www.cla-val.com
X143IP Intermediate Power Generator Mounting Instructions
X143IP
inlet piping
outlet piping
Install in the body
tappings on the opposite
side of pilot system
pre-assembled
retrofit kit
correct
installation
SAFETY PRECAUTION
Isolate the control valve using main line isolation
valves and bleed pressure before removing body plugs
Step 1: Unthread inlet and outlet piping from pre-assembled
retrofit kit
Step 2: Thread inlet piping into inlet tapping and outlet
piping into outlet tapping
Step 3: Install X143IP Power generator onto outlet piping
Step 4: Make electrical connections as described in the
Wiring Instructions on page 2; Proceed with Start-Up as
described on page 3
outlet
inlet
inlet
outlet
bypass
isolation valve