Cla-Val 136-03/636-03 Technical Manual - Manual (Page 23)

wave
washer
valve
bonnet
bonnet
gasket
core
plugnut/core tube
sub-assembly
Remove red cap and
push solenoid down.
Then pry here to lift
nameplate/retainer
and push to remove.
solenoid
with 1/2" NPT
For special wrench
adapter order kit
No. K218-948.
0.750-28 UN-2A
thread
Tapped hole in core
0.250-28 UNF-2B
0.38 minimum full thread.
red cap
nameplate/
retainer
grounding wire -
green or green with
yellow stripes
solenoid base
sub-assembly
0.9375-26 UNS -2A
thread
core
(DC) core
(AC)
spring washer
3/4" Bonnet Construction 15/16" Bonnet Construction
Side View
collar to face
valve body
finger
washer
Alternate
Construction
Remove red cap and
push solenoid down.
Then pry here to lift
nameplate/retainer
and push to remove.
See torque chart
for bonnet screws
red cap
nameplate/
retainer
spacer
solenoid
finger
washer
valve
bonnet
core
tube
Bolted Bonnet
Construction
red cap
nameplate/retainer
solenoid with 1/2" NPT
1.312 diameter
mounting hole
grounding wire -
green or green with
yellow stripes
.062 to .093 maximum
thickness of panel
for mounting
plugnut/core tube
sub-assembly
core
For special wrench
adapter order kit
No. K218-948
bonnet
gasket
valve
bonnet
spring
washer
retainer
core
solenoid base
sub-assembly
finger washer
0.69 diameter
mounting hole
Remove red cap and
push solenoid down.
Then pry here to lift
nameplate/retainer
and push to remove.
3/4" Bonnet Construction 15/16" Bonnet Construction
Part Name
solenoid base sub-assembly
valve bonnet (3/4" bonnet constructions)
bonnet screw (3/8" or 1/2" NPT pipe size)
bonnet screw (3/4" NPT pipe size)
Torque Value in inch-Pounds
175 ± 25
90 ± 10
25
40
Torque Value in Newton-Meters
19.8 ± 2.8
10.2 ± 1.1
2.8
4.5
Torque Chart
Figure 1. Series 8016G solenoids
Figure 2. Series 8016G solenoid Figure 3. Series 8016G panel mounted solenoids