Physio-Control LUCAS 2 User Manual

Page 13

LUCAS

2 Chest Compression System – Instructions for Use

4.2 The Battery

The proprietary Lithium Polymer (LiPo)
Battery is the exclusive power source for
LUCAS. You can remove the Battery from
LUCAS and recharge it. The Battery is
mechanically keyed in LUCAS and in the
Battery Charger to make sure you get the
correct installation. The top of the Battery
has connections for power and
communications to the Battery Charger and
to LUCAS.

4.2.1 Charge the Battery

You can charge the LUCAS Battery in two
ways:

• In the external LUCAS Battery Charger

(optional)

- put the Battery in the slot of the

Battery Charger,

- connect the Battery Charger power

cord to the mains wall outlet.

• Installed in LUCAS:

- put the Battery in the slot of the hood

of LUCAS,

- connect the Power Supply to the DC

input on the side of LUCAS,

- connect the Power Supply to the

mains wall outlet.

Green LEDs indicate a fully charged Battery.

Caution - keep Battery installed
The Battery must always be installed for
LUCAS to be able to operate, also when
powered by the external Power Supply.

Caution - use only approved
accessories
Use only JOLIFE AB-approved accessories
with LUCAS. LUCAS does not operate
correctly if you use accessories that are not
approved. Use only LUCAS Batteries and
the LUCAS Power Supply that are designed
for LUCAS. If you use other batteries or
Power Supply you can cause permanent
damage to LUCAS. This also voids the
warranty.