Gotham Elevations Performance Decorative Pendant PDPF, Candéo and Ice User Manual

Page 2

Figure 1C

10. Position the complete assembly to align the "V" notch on the

canopy with the "V" notch inside the mounting pan. Tuck in all
wires, close assembly to mounting pan and twist to engage
screws into L-slots (See Figure 1D).

11. Tighten screws. INSTALLATION COMPLETE.

Cord Mount (PDPF, Candéo and Ice)
I. Ground Prep
1. Temporarily remove top cap and any round decorative piece to

expose support bracket.

2. Removing socket assembly from box, attach socket cup to trim

(per trim instructions).

3. Route wires from reflector/socket assembly through bottom of

housing and plug into ballast assembly. Attach the ballast as-
sembly to top of housing with the attached screws.

4. Bundle ballast source wires under bracket (do not pass wires

through bracket center hole).

5. Replace the top cap and round decorative piece, leaving

screws loose for later steps.

6. Measure desired hanging length from ceiling to top of fixture,

then subtract the thickness of the canopy and add 6 inches.
**Ceiling suspension length - canopy thickness + 6 inches =
cord length.**

7. Strip off 4 inches of cord jacket to expose inner conductors.

Strip ½ inch from each conductor to expose copper.

8. Secure the provided strain relief bushing with a minimum of 2

inches above the stripped edge of the cord. Use pliers or vice-
grips to crimp around the cord jacket – flat side facing up. IF
ADJUSTMENT IS REQUIRED, USE EITHER A FLATHEAD SCREW-
DRIVER TO PRY-OFF BUSHING AND RECRIMP, OR CUT BUSHING
OFF AND USE EXTRA ONE PROVIDED (See Figure 2C).

9. Remove the fixture cap to expose support bracket and to route

cord through top center hole.

10. VERIFY CORD IS ROUTED THROUGH CAP AND ANY ROUND

DECORATIVE PIECES ARE ON FIXTURE! Align cord-attached
bushing to bracket hole and press firmly into support bracket
until all three snaps engage. Flat ledge of bushing should sit
flush with bracket surface.

11.

WARNING! Possible falling hazard and risk of serious

injury. Gather both cord and socket leads into tie strap strain
relief so that a minimum of two inches of cord conductors with
socket conductors are pulled inside tie strap. Make connec-
tions with wire nuts. Pull tie strap tight enough to strain relieve
all connections. Trim excess strap material (See Figure 2D).

12. Separate j-box mounting pan from top of canopy by loosening

the 3 side screws, twisting and removing.

II. Ceiling Installation
13. Hang mounting pan by routing j-box wires through back of

pan, and using either 3.5 or 4.5 inch key holes, secure to j-box
(See Figure 1C).

14. With canopy and fixture suspended on cord, make power

connections using wire nuts.

15. Align the “V” notch on the outer canopy with the “V” notch

inside the mounting pan. Tuck in all wires, close assembly to
mounting pan and twist to engage screws into L-slots (See
Figure 1D).

16. Tighten screws. INSTALLATION COMPLETE.

Fixture connections and hanging instructions

Part No. CJ52008

Rev B. 11/07

Elevations

- Part I

Figure 1D

Figure 2C

1/2

Figure 2D