Gotham 4 Elevations Wall Mount - Low Voltage - Manual

INSTALLATION INSTRUCTIONS
4" Elevations
TM
Performance Downlight Pendant
Wall Mount - Low Voltage
For Your Protection, Read Carefully
- Risk of fire. Do not install
insulation within 3 inches of fixture sides
or wiring compartment, nor above the
fixture in such a manner as to entrap
heat.
• Turn off the power supply.
• Ground the fixture to avoid poten-
tial electrical shocks.
• Do not handle an energized fixture
or energize any fixture with wet
hands, when standing on a wet or
damp surface, or in water.
• Double check all electrical connections
to be sure they are tight and correct.
• Match wattage of fixture and lamp
exactly.
• Do not remove or insert lamp when
power is on.
• Do not scratch glass or subject lamp
to undue pressure as either may
cause lamp breakage.
• Protect operating lamp from sources
of moisture.
©2006 Gotham
4" Elevations TM
Page 1 of 2
Figure 4
SAVE THESE INSTRUCTIONS
Figure 1
Figure 2
Figure 3
-
1. Remove J-box mounting bracket from
hardware kit.
2. Mount the bracket to the J-box using
the flush-head screws provided. Be
sure that the thumbscrew is on top.
FIGURE 1.
3. Once bracket is installed onto J-box
securely, loosen thumbscrew 1/8 inch
from bracket, but be sure not to remove.
BRACKET INSTALLATION COMPLETE.
1. Remove reflector ASM from box.
2. Make connections between socket
leads and housing leads
3. Insert reflector into housing, making
sure to align arrow on socket with
arrow inside housing.
4. Press reflector ASM into housing until
flange is flush.
5. Remove top and bottom screws from
wall canopy. Temporarily store screws.
6. Slide canopy away to expose the inner
bracket assembly and side screws.
FIGURE 2.
7. Remove side screws from inner bracket
to allow the fixture arm to pivot, then
lock arm in open position by temporarily
inserting side-screws into secondary
locking holes on each side. FIGURE 3.
1. Route supply wires from J-box through
the ½ inch hole of rear bracket, being
sure to pull them through to allow wiring
access.
2. Hang fixture onto J-box using the rear
bracket keyhole slot and J-box thumb-
screw. Tighten thumbscrew with fingers
to secure fixture onto wall. FIGURE 4.
3. From hardware bag, loosely install #8
screw through inner bracket slot into
J-box bracket. Use level to plumb
fixture and once adjusted vertically,
tighten screw with tool to lock position.
Upon receipt, thoroughly inspect for any freight
damage which should be brought to the
attention of the delivery carrier. Compare the
catalog description listed on the packing slip
with the label on the carton to ensure that you
have received the correct merchandise.