Gotham HEQ - Manual (Page 2)

Figure 6
Figure 7
CJ520717 Rev. A
3/2009
2 of 2
Figure 5
A
B
7. Feed power supply to J-box. (See Figure 5)
- J-box is approved for through wiring with eight No. 12 AWG
conductors (4 in/4 out) rated 90°C or higher.
- Remove J-box cover by releasing spring clip (See Figure 5A) and
allowing cover to hinge open (See Figure 5B).
- Select desired knockout, remove and install appropriate connector.
- Install power conductors in accordance with all local and/or National
Electric Codes and ordinances (consult your local building authority for
specific requirements).
- Make connections using code approved materials/methods.
-Reinstall J-box cover (See Figure 5B).
8. Install ceiling material, cut hole out for drop down flange (7” x 9 ¾”
ceiling opening), being careful not to cut the hole too large.
9. Insert lens in trim by sliding into spring brackets. (See Figure 6).
10. Install lamp (this fixture requires a coated (frosted) T-4 mini-can
base lamp). Consult label on inside of drop down flange of housing for
specific wattages appropriate for your fixture. Fixtures are wattage
specific. Be sure to read and follow all of the lamp manufacturers
directions and recommendations.
11. Place torsion springs into slots in mounting frame and push trim
into place. (See Figure 7)
12. To access junction box, slightly loosen two thumb screws along
lower inside edge of housing. Move upper housing to the side to
access junction box. Replace housing before energizing.
WARNING: DO NOT ENERGIZE FIXTURES WITHOUT FINISH TRIM
IN PLACE. PROTECTIVE GLASS SHIELD MUST BE USED WITH
THIS FIXTURE AT ALL TIMES.
SAVE THESE INSTRUCTIONS