Gotham Incito DMX512_RDM Field Rev. F - Manual (Page 2)

CJ520003 Rev. F
©2012 Acuity Brands Lighting, Inc.
All Rights Reserved.
2 of 12
IMPORTANT SAFETY INFORMATION
For Your Protection, Read Carefully

To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts,
cuts/abrasions, and other hazards please read all warnings and instructions included with and on the fixture box
and all fixture labels.

Before installing, servicing, or performing routine maintenance upon this equipment, follow these general
precautions.

Installation and service of luminaires should be performed by a qualified licensed electrician.

Maintenance of the luminaires should be performed by person(s) familiar with the luminaires’ construction and
operation and any hazards involved. Regular fixture maintenance programs are recommended.
 It will occasionally be necessary to clean the outside of the refractor/lens. Frequency of cleaning will depend on
ambient dirt level and minimum light output which is acceptable to user. Refractor/lens should be washed in a
solution of warm water and any mild, non-abrasive household detergent, rinsed with clean water and wiped
dry. Should optical assembly become dirty on the inside, wipe refractor/lens and clean in above manner,
replacing damaged gaskets as necessary.
 DO NOT INSTALL DAMAGED PRODUCT! This luminaire has been properly packed so that no parts should have
been damaged during transit. Inspect to confirm. Any part damaged or broken during or after assembly should
be replaced.

Recycle: For information on how to recycle LED electronic products, please visit www.epa.gov .

These instructions do not purport to cover all details or variations in equipment nor to provide every possible
contingency to meet in connection with installation, operation, or maintenance. Should further information be
desired or should particular problems arise which are not covered sufficiently for the purchaser’s or owner’s
purposes, this matter should be referred to Acuity Brands Lighting, Inc.
 Disconnect or turn off power before
installation or servicing.
 Verify that supply voltage is correct by
comparing it with the luminaire label
information.
 Make all electrical and grounded
connections in accordance with the
National Electrical Code (NEC) and any
applicable local code requirements.
 All wiring connections should be capped
with UL approved recognized wire
connectors.
WARNING
RISK OF ELECTRIC SHOCK
 Allow lamp/fixture to cool before
handling. Do not touch enclosure or light
source.
 Do not exceed maximum wattage
marked on luminaire label.
 Follow all manufacturer’s warnings,
recommendations and restrictions for:
driver type, burning position, mounting
locations/methods, replacement and
recycling.
WARNING
RISK OF BURN
 Wear gloves and safety glasses at all
times when removing luminaire from
carton, installing, servicing or performing
maintenance.
 Avoid direct eye exposure to the light
source while it is on.
CAUTION
RISK OF INJURY
 Keep combustible and other materials
that can burn, away from lamp/lens.
 Do not operate in close proximity to
persons, combustible materials or
substances affected by heat or drying.
CAUTION
RISK OF FIRE