Gotham Evo_Incito Flangeless Round & Square - Manual (Page 2)

CJ5200914 Rev. A
©2010 Acuity Brands Lighting, Inc.
All Rights Reserved.
2 of 2
SAVE THESE INSTRUCTIONS
(Cont.)
4. Install plaster guard to protect mudring and inside of fixture from plaster and paint (see Figure 4).
5. Apply mud to mudring being sure to mud up to the edge of the mudguard. Smooth and feather out. Allow to dry between coats. Repeat
until all edges surrounding mudguard are filled and a smooth surface exists over the mudring. Several coats of mud are recommended
(see Figure 5 & 6).
6. Prior to sanding, use tape to cover hole in plaster guard. Sand with 150-grit sandpaper or finer
7. Score around perimeter of plaster guard before removing to ensure clean surface. Re-install plaster guard for painters.
8. After painting is completed (see Figure 7), remove plaster guard and install trim per instructions that ship with trim being careful to keep trim
level during installation.
Figure 5
Figure 6
Figure 4
Figure 7