Gotham EVO R Retro-fit - Manual (Page 2)

CJ5201009 Rev. J
11/2013 2 of 8
©2010, 2011 Acuity Brands Lighting, Inc.
All Rights Reserved.
SAVE THESE INSTRUCTIONS
Upon receipt, thoroughly inspect for any
freight damage which should be brought
to the attention of the delivery carrier.
Compare the catalog description listed on
the packing slip with the label on the
carton to ensure you have received the
correct merchandise.
INSTALLATION INSTRUCTIONS
EVO R
Retro-fit
IMPORTANT SAFETY INFORMATION
For Your Protection, Read Carefully
WARNING: RISK OF FIRE OR
ELECTRIC SHOCK. DO NOT ALTER,
RELOCATE, OR REMOVE WIRING,
LAMPHOLDERS, POWER SUPPLY, OR
ANY
OTHER ELECTRICAL
COMPONENT.
WARNING: RISK OF FIRE OR
ELECTRIC SHOCK. INSTALLATION OF
THIS RETROFIT ASSEMBLY REQUIRES
A PERSON FAMILIAR WITH THE
CONSTRUCTION AND OPERATION OF
THE
LUMINAIRE’S ELECTRICAL
SYSTEM AND THE HAZARD
INVOLVED. IF NOT QUALIFIED, DO
NOT
ATTEMPT INSTALLATION.
CONTACT A QUALIFIED ELECTRICIAN.
WARNING: RISK OF FIRE OR
ELECTRIC SHOCK. INSTALL THIS KIT
ONLY IN THE LUMINAIRES THAT HAS
THE CONSTRUCTION FEATURES AND
DIMENSIONS
SHOWN IN THE
PHOTOGRAPHS AND/OR DRAWINGS.
DO NOT MAKE OR ALTER ANY OPEN
HOLES IN AN ENCLOSURE OF WIRING
OR
ELECTRICAL COMPONENTS
DURING KIT INSTALLATION.
WARNING: TO PREVENT WIRING
DAMAGE OR ABRASION.
DO NOT
EXPOSE WIRING TO EDGES OF SHEET
METAL OR OTHER SHARP OBJECTS.
RETROFIT KIT SHALL BE INSTALLED
ONLY IN THE INTENDED MANNER AND
LOCATION.
SUITABLE FOR WET LOCATIONS
COVERED CEILING MOUNT ONLY.
SUITABLE FOR TYPE NON-IC
LUMINAIRES.
SUITABLE FOR USE IN ENCLOSED
RECESSED LUMINAIRES.
Figure 1 Figure 2
Figure 3 Figure 4
Retrofit assembly components:
1. Wiring compartment with LED driver attached and LED light engine connected with flex.
2. Trim retaining springs and brackets.
Direct LED downlighting retrofit kit instructions:
To retrofit the fixture using this product, customers must have Gotham housings (GRSF, GRSH, GRS, AFV or
LGFV) as shown in Figure 1 and subsequent photos.
1. Disconnect power to light fixture.
2. Remove existing reflector from ceiling, disconnect socket cup assembly and set aside.
3. For horizontally lamped fixtures with a yoke assembly, remove the yoke by releasing springs on both sides
of yoke as shown in Figure 2. For vertically lamped fixtures with a yoke, remove yoke by pushing each side
outward as shown in Figure 3. Discard yoke.
4. Install torsion spring retention brackets (shown in Figure 4) on mounting frame.
5. Remove inner junction box door and disconnect power supply. Remove outer junction box door and
discard. Pass LED retro-fit driver assembly through aperture snapping new LED driver assembly to outside
of junction box as shown is Figure 5. Wiring per diagrams below Figure 6 (120V or 277V) or Figure 7
(347V). Snap on inner junction box door.
6. Attach new LED downlight trim to LED light engine assembly, see trim instruction (CJ5201007 shipped
separately).
7. For 347V wiring see diagram below (Figure 7).