Extron Electronics RGB 164xi User Guide - Manual (Page 13)

RGB 130xi xi xi xi xi, 134xi xi xi xi xi, 160xi xi xi xi xi, 164xi xi xi xi xi • Specifications, Part Numbers,
and Templates
RGB 130xi xi xi xi xi, 134xi xi xi xi xi, 160xi xi xi xi xi, 164xi xi xi xi xi • Specifications, Part Numbers,
and Templates
Specifications, Part Numbers, and Templates
Specifications
Video
Gain ............................................... Unity, (0.725V p-p) 50% peaking, (0.75V
p-p) 100% peaking
Bandwidth .................................... 300 MHz (-3dB)
Video input
Number/signal type ................... 1 analog RGBHV, RGBS, RGsB, RsGsBs
Connectors .................................... RGB 130xi, RGB 134xi ............... 1 9-pin D
male
RGB 160xi, RGB 164xi ............. 1 15-pin HD
female
Minimum/maximum levels ...... Analog ....... 0.3V to 1.5V p-p with no
offset at unity gain
Impedance .................................... RGB 130xi, RGB 134xi ............. 75 ohms or
Hi Z,
switchable
(set to 75
ohms if no
local
monitor is
connected)
RGB 160xi, RGB 164xi ............. 75 ohms
Horizontal frequency .................. Autoscan 15 kHz to 130 kHz
Vertical frequency ....................... Autoscan 30 Hz to 120 Hz
Return loss .................................... -30dB @ 5 MHz
Maximum DC offset .................... 4.0V
Video output
Number/signal type ................... RGB 130xi, RGB 160xi ............. 1 analog
RGBHV, RGBS, RGsB
RGB 134xi, RGB 164xi ............. 2 analog
RGBHV, RGBS, RGsB
Connectors .................................... RGB 130xi, RGB 160xi ............... 6 BNC
female
RGB 134xi, RGB 164xi ............. 2 x 6 BNC
female
RGB 160xi, RGB 164xi ............. 1 15-pin HD
female local monitor buffered output
Minimum/maximum levels ...... Analog ....... 0.7V to 0.75V p-p with 0.70V
p-p input
Impedance .................................... 75 ohms
Return loss .................................... -30dB @ 5 MHz
Sync
Input type ..................................... RGBHV TTL (±), RGBS TTL (±), RGsB
0.3V (-), RsGsBs 1.3V (-)
Output type .................................. RGBHV (±), RGBS(±), RGsB (-)
Input level ..................................... 2V to 5.5V p-p with ±0.2VDC offset (max.)
Output level .................................. 4V to 5V p-p
Input impedance .......................... 510 kohms
Output impedance ...................... 75 ohms
Max. propagation delay .............. 48 nS
Max. rise/fall time ....................... 3.5 nS
Polarity .......................................... RGBHV ...................... when RGBHV is
input, polarity
follows input;
otherwise negative
RGBS, RGsB .............. negative
Audio
Gain ............................................... Unbalanced 0dB, balanced +6dB
Frequency response ..................... 20 Hz to 20 kHz, ±0.05dB
THD + Noise ................................ 0.03% @ 1 kHz, 0.3% @ 20 kHz at rated
maximum output drive
S/N ................................................ >90dB, at the rated maximum output
(14dBu), balanced
Stereo channel separation .......... >95dB @ 1 kHz to 20 kHz
Audio input
Number/signal type ................... 1 PC level stereo, unbalanced
Connectors .................................... 1 3.5 mm stereo jack, 2 channel; tip (L),
ring (R), sleeve (ground)
Impedance .................................... >10 kohms, DC coupled
Maximum level ............................ +8.5dBu,(unbalanced) at stated %THD+N
Audio output
Number/signal type ................... 1 stereo (2 channel), balanced/unbalanced
Connectors .................................... 1 3.5 mm captive screw connector, 5 pole
Impedance .................................... 50 ohms unbalanced, 100 ohms balanced
Gain error ...................................... ±0.1dB channel to channel
Maximum level (600 ohm) ......... >+14dBm, balanced at stated %THD+N
A-3 A-2