Extron Electronics TeamWork Kits Installation - Manual (Page 9)

9
VGA “Show Me” Cables
1. Connect the input end of the VGA “Show Me” cable to the source device.
2. Connect the output of the “Show Me” cable to the VGA input of the analog-to-digital converter.
3. Connect the HDMI cable from the digital output of the converter to the HDMI input of the switcher.
0.3A MAX
POWER
12V 1
Tx Rx
RS-232 AUTO
2 3 4
INPUTS SW4 HDMI REMOTE
1 2 3 4 G
CONTACT
1 2 3 4 +V
TALLYOUT
OUTPUT
12V 1.0A MAX
POWER
RS-232
Tx Rx
INPUT
AUDIO RGB - HDMI 300 A HDMI OUTPUT RGB/R-Y,Y,B-Y
SHARE
Three-conductor
pigtail for contact
closure and tally.
Tx Rx
RS-232 AUTO
REMOTE
1 2 3 4 G
CONTACT
1 2 3 4 +v
TALLY OUT
Green
Yellow
Pigtail
Drain wire
(not used)
a
b
c
e SHOW ME CABLE
SWITCHER END
(output)
Male VGA Connector
SHOW ME CABLE
SOURCE END
Extron Analog-to-Digital Converter
Extron HDMI Switcher
4
4. (Optional) Connect the audio output from the source device to the 3.5 mm TRS audio input on the converter (the cable is not
provided with the TeamWork VGA kit). The audio signal is embedded in the HDMI output signal.
5. Connect the Green (Tally Out) and Yellow (Contact) pigtail wires as shown above. The number under the Tally Out and
Contact pins must correspond to the video input on the switcher.
NOTES:
• The drain wire does not need to be wired to the switcher. The “Show Me” cables are grounded via the video
connectors.
• Do not connect the “Show Me” cable to the +V pin on the Extron switcher.
Press the Share button to switch the connected source to the main presentation display.
Pressing the Share button creates a momentary contact closure, which triggers the switcher to select the connected source
device. If a tally output is available, the button will light up blue.
NOTE: The source device provides the +5 VDC supply voltage needed to illuminate the Share button. If the source device
does not supply this +5 VDC, the Share button will not illuminate. Some mobile devices do not provide the required
voltage to light up the button.