Extron Electronics TeamWork Installation - Manual (Page 2)

TeamWork • Installation Guide (Continued)
2
Mounting and Installation
Assembling the Cable Cubby
1. Install the power modules in the Cable Cubby. The power modules that you use depend on the country you are in and the
Cable Cubby model that you are using. For complete installation instructions for your Cable Cubby, see the installation guide
for that Cable Cubby, which is available at
www.extron.com .
WARNING: Possible electric shock: To ensure good electric grounding, you must secure the power modules to the
Cable Cubby using screws with star washers.
2. Assemble the AAP shelf assembly and “Show Me” cables.
The AAP shelf assembly components will depend on the Cable Cubby you are using. Follow the instructions in the
Cable Cubby installation guide.
ATTENTION: The “Show Me” cables must be integrated into the AAP shelf assembly as it is being put together. Ensure
that they are installed in the correct orientation:
• The end with the button and LED connects to the input devices and must come out of the top of the Cable Cubby.
• The end with the three-conductor pigtail connects to the switcher and must come out of the bottom of the Cable
Cubby.
HDMI “Show Me” cable
INPUT
(to source device)
Top of Cable Cubby
OUTPUT
(to switcher)
Bottom of
Cable Cubby
Share Button Three-conductor
pigtail for contact
closure and tally
VGA “Show Me” cable
SHAR
E
INPUT
(to source device)
Top of Cable Cubby
OUTPUT
(to switcher)
Bottom of
Cable Cubby
Share Button
Three-conductor
pigtail for contact
closure and tally
Display Port
“Show Me” cable INPUT
(to source device)
Top of Cable Cubby
OUTPUT
(to switcher)
Bottom of
Cable Cubby
Share Button
Three-conductor
pigtail for contact
closure and tally
SHARE
Mini Display Port
“Show Me” cable INPUT
(to source device)
Top of Cable Cubby
OUTPUT
(to switcher)
Bottom of
Cable Cubby
Share Button
Three-conductor
pigtail for contact
closure and tally
SHAR
E
3. Insert the AAP assemblies into the Cable Cubby from underneath and secure them in position with the provided #4-40
Phillips head screws and star washers.