Extron Electronics MLC 104 SIS Programming and Control - Manual (Page 10)

SIS ™ Programming and Control, cont’d
MLC 104 Series • SIS ™ Programming and Control 5-10
PRELIMINAR
Y
Enable lockout mode 3
24
3X
3X
Exe 3
Lock
all fr
ont panel selections and
adjustments via MLC and SCP
. Make
selections, changes, and configur
e features
via RS-232 or Ethernet only
.
All fr
ont panels
in the contr
ol system ar
e locked.
V
iew the lockout mode status
X
X
X209
Show lockout (executive mode) status. X209
= 0 (of
f, unlocked) or 3 (fr
ont panels
locked/disabled)
Example
:X
0
Executive mode is off
.
Status commands
V
iew lamp hours status
6S
6S
X205
*
X205
X205
r
epresents the number of elapsed hours
of projector lamp use. The MLC r
esponds
with 2 sets of lamp hours. The number of elapsed hours ar
e shown if a lamp’s status is
set. If a lamp’s status has not been set, it is shown as the default (99999 hours).
Set lamp hours status for 1 lamp
24
X205
*6S
X205
%2A 6S
Lhr
*
X205
*
X205
X205
r
epresents the five-digit numeric value
for elapsed lamp use hours, and it is used by script to determine the number sent in response to the “view lamp hours” command (6S).
24
= The MLC responds with an E24 err
o
r
(privilege violation) if the connected user is not logged in at administrator security level.
Set lamp hours status for 2 lamps
24
X205
*
X205
*6S
X205
%2A
X205
%2A 6S
Lhr
*
X205
*
X205
V
iew connection status
7S
7S
X216
This command lets you know whether the MLC’s scripts have determined if the display is still connected to the MLC. X216
= 0 (disconnected), 1 (connected), or
2 (unknown)
Set pr
ojector connection status
24
X216
*7S
X216
%2A 7S
Pcs
X216
This command is used to reset the pr
ojector
connection status flag (
X216
) used by scripts.
0 = projector not connected. 1 = projector is connected. 2 = undetermined status.
Command/r
esponse table for SIS commands (continued)
Command
ASCII
(T
elnet)
URL Encoded (W
eb)
Response
Additional description
(host to switcher)
(host to switcher)
(switcher to host)