Extron Electronics IN3526vi - Manual (Page 11)

7
© 1997 - INLINE, INC. IN3526VI OPERATION MANUAL - REV. 2 12/01/98
RS-232 Operation
Only Hold down the INPUT 3 button while applying power to the unit. The front panel
and contact closure remote control will be disables. The only way to switch the
unit is via RS-232 control. The front panel can be enable via RS-232 or by
resetting the unit to Factory Default.
Master Switcher Hold down the INPUT 4 button while applying power to the unit. This will set the
unit up as a master switcher (see Master/Slave Operation)
Scan Enable and
Setup Hold down the INPUT 5 button while applying power to the unit. Hold the button
until the INPUT 6 LED turns on. Upon releasing the button, the BLANK and
INPUT 6 LEDs will begin to flash (if you have a signal on Input 6 it will flash on
your screen.) Press one of the input buttons to select the inputs to scan:
INPUT 1 Disable Scanning
INPUT 2 Scan Inputs 1- 2
INPUT 3 Scan Inputs 1 - 3
INPUT 4 Scan Inputs 1 - 4
INPUT 5 Scan Inputs 1 - 5
INPUT 6 Scan Inputs 1 - 6
The BLANK and INPUT 6 LEDs will now begin flashing at a slower rate. Press
one of the input buttons to select the scan time interval:
INPUT 1 2.5 seconds
INPUT 2 5 seconds
INPUT 3 7.5 seconds
INPUT 4 10 seconds
INPUT 5 15 seconds
INPUT 6 20 seconds
BLANK 30 seconds
Baud Rate
Selection Hold down the BLANK button while applying power to the unit. Hold the button
until the INPUT 6 LED turns on. Upon releasing the button, the BLANK and
INPUT 6 LEDs will begin to flash (if you have a signal on Input 6 it will flash on
your screen.) . Press one of the input buttons to select the baud rate shown below.
INPUT 1 1200 Baud
INPUT 2 2400 Baud
INPUT 3 4800 Baud
INPUT 4 9600 Baud
INPUT 5 19200 Baud
Blank Setup Hold down the BLANK button while applying power to the unit. Hold the button
until the INPUT 6 LED turns on. Upon releasing the button, the BLANK and
INPUT 6 LEDs will begin to flash (if you have a signal on Input 6 it will flash on
your screen.) Press INPUT 6 or BLANK button to select the BLANK setup:
BLANK Send nothing to output when BLANK is selected
INPUT 6 Send sync from INPUT 1 to output when BLANK is
selected