Connect an hdmi output device – Extron Electronics HAE 100 User Guide User Manual
Page 11
b
HDMI input — Connect an HDMI input source into this female HDMI type A connector.
Pixel clock rates up to 225 MHz (2.25 Gbps per channel) are supported.
c
HDMI output — Connect an HDMI output device into this female HDMI type A
connector.
NOTES:
•
It is not required to connect an HDMI output device to extract audio from
the HDMI input device.
•
If the HDMI input signal is HDCP encrypted, the HDMI output signal will
also be encrypted. If the HDMI input signal is not HDCP encrypted, the
output signal will not be encrypted.
•
If the HDMI input signal is HDCP encrypted and the HDMI output device
is not HDCP compliant, the unit will output a green screen.
d
S/PDIF audio output — Connect an S/PDIF audio output device into this female RCA
connector. This connector outputs digital S/PDIF audio formats (2-channel LPCM,
Dolby Digital, or DTS).
NOTE: The audio format that is present on this output is determined by the content
on the source device (see the "
more information).
e
Audio Format toggle switch — This toggle switch is used to select the audio format
that the HAE 100 will extract from the HDMI input signal. The position of this toggle
switch also governs the EDID presented to the input source device.
NOTE: See the "
" on page 9 for more information on
using this switch with EDID.
z
z
Analog (up) — When the Audio Format toggle switch is set to this position, the
2-channel PCM audio signal is extracted from the HDMI input signal and output
as a stereo analog signal via the analog output connector. 2-channel PCM audio is
simultaneously output via the S/PDIF audio output. The HAE 100 provides EDID to
the input source which lists support for 2-channel LPCM audio only.
z
z
S/PDIF (down) — When the Audio Format toggle switch is set to this position, the
S/PDIF audio signal is extracted from the HDMI input signal and output via the
S/PDIF output connector. The HAE 100 provides EDID to the input source which lists
support for 2-channel LPCM, Dolby Digital (up to 6 channels), and DTS (up to
7 channels).
f
Analog audio output — Connect an audio output device to this 5-pole 3.5 mm
captive screw connector (see figure 5). This connector outputs a 2-channel stereo analog
audio format.
Unbalanced Output
Balanced Output
Tip
Ring
Tip
Ring
LR
Sleeve(s)
Do not tin the wires!
Tip
NO GROUND
Tip
NO GROUND
LR
Sleeve(s)
CAUTION
For unbalanced audio, connect the
sleeve(s) to the ground contact.
DO NOT
connect the sleeve(s) to the
negative (-) contacts.
Figure 5.
Analog Output Connector Wiring
HAE 100 HDMI Audio Extractor • Panels and Cabling
6