Extron Electronics FOX 3G HD-SDI User Guide - Manual (Page 24)

PMK 350 mounting
Mount the transceiver to a PMK 350 bracket as follows:
1. Remove the front and rear plates from the PMK 350 (figure 13), using a Tweeker or a
#2 Phillips screwdriver . Retain the screws to reattach the plates when you are finished.
Extron
PMK 350
Multi-product Pole
Mount Kit
Cover Sheet
Front Plate
Rear Plate
U-bolt
L-shaped
Bracket
Contoured
Base
Extron
Power Supply
Extron
Quarter-rack
Sized Product
Figure 13. PMK 350 Projector Mounting a Transceiver
2. If necessary, remove the feet from the bottom of the transceiver.
3. Secure the transceiver to one side of the mounting tray, using two of the supplied
4-40 x 3/16-inch screws in opposite (diagonal) corners.
4. If power supply is connected to the transceiver, use the two included tie wraps to strap
the power supply to the bracket.
5. Place the PMK 350 around the projector ceiling mounting pole (figure 13).
FOX 3G HD-SDI • Reference Information 20