Extron Electronics FOX 3G HD-SDI User Guide User Manual
Page 23
3.
If the power supply is connected to the transceiver, use the two included tie wraps
to strap the power supply to one of the brackets.
NOTE: The PMK 300 has a hole in the bottom plate that allows the projector pole
to be inserted through the center of the plate (figure 12, below), rather than
outside of the plate (
). To install the PMK 300 in this configuration,
slide the bracket up from the bottom of the pole before the projector is
installed on the pole.
U-Bolt
Extron
PMK 300
Multi-product Pole
Mount Kit
Bracket
Brace
Figure 12.
Projector Pole on the Inside
4.
Place the contoured bracket brace against the pole and opposite the back plate. The
pole should fit snugly into the depression in the center of the bracket brace.
5.
Place the U-bolt around the ceiling pole. Insert the two legs of the U-bolt through the
round holes on the contoured bracket brace and then through the slotted holes on the
mounting plate of the bracket.
NOTE: The supplied U-bolt fits a typical (1.5 inch to 2.0 inch diameter) ceiling pole.
FOX 3G HD-SDI • Reference Information
19