Extron Electronics FOX 3G HD-SDI User Guide - Manual (Page 22)

Projector Mounting
The transceiver can be mounted on a projector bracket using either of the following optional
Extron projector mounting kits:
• PMK 300 multi-product pole mount kit (part #70-374-01)
• PMK 350 low profile, multi-product pole mount kit (part #70-563-02 [black] or
part #70-563-03 [white])
PMK 300 mounting
Mount the transceiver to a PMK 300 bracket as follows:
1. If necessary, remove the feet from the bottom of the transceiver.
2. Mount the transceiver to one of the three mounting plates on the bracket using two of
the supplied 4-40 x 3/16-inch screws in opposite (diagonal) corners to secure the device
to the bracket. It can be vertically mounted facing either up or down (figure 11).
Extron
PMK 300
Multi-product Pole Mount Kit
U-Bolt
Front Mounting
Plate
Side Mounting
Plate
Extron
Quarter-rack
Sized Product
Power Supply
Bracket
Brace
Figure 11. PMK 300 Projector Mounting a Transceiver
NOTE: On the side mounting plates, the device is typically mounted on the outside
of the bracket.
On the front mounting plate, the device is typically mounted on the inside of
the bracket.
FOX 3G HD-SDI • Reference Information 18