Extron Electronics FOX 3G HD-SDI User Guide - Manual (Page 21)

Through-furniture mounting
The transceiver can be mounted through a desk or other furniture using an optional
MBD 129 through-desk mounting kit, part #70-077-02. Mount the transceiver through a
desk or table as follows (figure 10):
Figure 10. Through-desk Mounting
1. Loosely attach the mounting brackets to the transceiver using the four machine screws
and washers supplied with the mounting kit.
2. Hold the transceiver against the inside of the surface through which it will be mounted.
Mark the four screw holes and the table material to be removed on the inside of the
surface to which you are mounting the device.
3. Remove the table material. Test the fit by inserting the front of the device through the
hole. If necessary, use a rasp or coarse file to enlarge the hole.
4. Drill four pilot holes, each 3/32 inch in diameter by 1/4 inch deep, where you made
marks.
5. Using the provided four wood screws, secure the brackets to the mounting surface.
6. Slide the transceiver up and down in the mounting brackets until the face of the
transceiver is at the desired height. Tighten the screws that secure the brackets in place.
If the screws are inaccessible to a screwdriver:
a. Mark the location of the brackets relative to the screws.
b. Remove the transceiver from inside the furniture.
c. Tighten the screws.
d. Replace the unit inside the surface (step 5).
FOX 3G HD-SDI • Reference Information 17