Extron Electronics DXP DVI Pro Setup Guide - Manual (Page 23)

17 DXP DVI Pro and DXP HDMI Series • Operation
• Advanced features consist of:
• Setting video and audio output mutes
• Creating I/O groups
• Setting the RS-232/RS-422 port protocol and baud rate
NOTE: The switcher is shipped from the factory in lock
mode 2.
Selecting lock mode 2 or toggling between lock modes 2
and 0
NOTES: • If the switcher is in lock mode 0 or 1, this procedure
selects mode 2.
• If the switcher is in lock mode 2, this procedure selects
mode 0 (unlocks the switcher).
Toggle the lock on and off by pressing and holding the Enter, Video,
and Audio buttons simultaneously until the following buttons blink
twice (approximately 2 seconds).
• The Esc, Video, and Audio buttons blink if the DXP is now in lock
mode 2.
• The Video and Audio buttons blink if the DXP is now in lock
mode 0.
I / O
I / O
AUDIO VIDEO ENTER
ENTER VIDEO
Press and hold simultaneously.
The buttons blink twice.
Release the buttons.
2 seconds
AUDIO
Figure 16. Press and Hold the Enter and the Two I/O Buttons
Simultaneously
Selecting lock mode 2 or toggling between modes 2
and 1
NOTES: • If the switcher is in lock mode 1, this procedure selects
mode 2.
• If the switcher is in lock mode 2, this procedure selects
mode 1 (locks all switcher functions except selecting
mode 2).