Extron Electronics CTL208CM - Manual (Page 3)

CTL208CM Control Panel Module • Quick Start Guide
CAUTION Installation and service must be performed by authorized
personnel only. These units must be installed in
accordance with national and local electrical codes.
Step 1
Power off all devices and disconnect them from the power source,
if necessary.
Step 2
Run the serial cable between the control panel module’s installation
location and the device to be controlled.
Step 3
As necessary, install a wall box, table connector bay, or other mini-
AAP mounting option into which the control panel module will be
installed.
Step 4
Configure the control panel module’s rear panel DIP switches.
Step 5
Connect a serial cable between the control panel module and a
computer.
Step 6
Connect the external power supply to the control panel module.
Step 7
Program the control panel module’s buttons as desired, using either
the Extron ICS100 control software or the Extron ASCII character
command set.
Step 8
If necessary, set the control panel module’s serial control settings to
match those of the device to be controlled using the Extron ASCII
character command set.
Step 9
Disconnect the serial control cable from the computer and install the
serial control cable between the control panel module and the device
to be controlled.
Quick Start Guide — CTL208CM
QS-1