Extron Electronics Cable Cubby 200 - Manual (Page 9)

Cable Cubby 200 • Before Getting Started 4
Planning
Determine the best location for the enclosure. Before making any cuts:
• Ensure that the location where the Cable Cubby is to be installed is convenient for as
many users as possible.
• Ensure that the edge on which the lid opens is oriented correctly.
• Ensure that there is ample space under the table for cables.
• Ensure that the correct template or dimensions are used.
NOTE: The table to host the Cable Cubby 200 must have a thickness of at least 3/8
inch (9.5 mm) to ensure that there is enough table material for the mounting
screws to securely fasten the Cable Cubby to the table.
Decide on the method for cutting the hole in the table.
• Hand router and template (recommended)
• CNC wood router
• Jigsaw and paper template
Before starting the installation, check with local and state regulations.
• Ensure that the planned installation complies with building and electrical codes.
• Ensure that the planned installation complies with the Americans with Disabilities Act or
other accessibility requirements.
Tools and Equipment Required for Installation
Extron recommends the following equipment (not provided) to ensure the Cable Cubby is
properly installed:
Safety Glasses
Phillips Screw Driver
Tape Measure
Marking Pen
Vacuum Cleaner
Square
Drill
1/4" Hex Nut Driver