Xylem System 5000 Getting Started Guide - Manual (Page 16)

14
SYSTEM 5000™ SOFTWARE
Enabling/Disabling Scanning
Once the System 5000™ has been set up
as desired, Scanning should be enabled.
Press any “OK” or “Exit” buttons necessary
until the “Main Menu” screen is displayed.
The Scanning indicator is red when
Scanning is Off or disabled. All Tasks as
well as any incoming events will not be
processed when Scanning is Off on the
System 5000™.
Press the red Scanning indicator or
“Scanning is Off” text to turn scanning on.
All Tasks will now be processed according
to their scan rates. The next scan time is
shown when scanning is enabled.
To disable scanning, simply press the
Scanning indicator or “Scanning is On”
text.