Xylem System 5000 Getting Started Guide - Manual (Page 12)

10
SYSTEM 5000™ SOFTWARE
Once a Task label has been defined,
press “Select Input” on the “Edit Task”
screen.
To retrieve the voltage of the battery,
select “Battery Voltage” from the list of
available inputs. Press the “OK” button
to open the Battery Voltage Properties
page.
De-selecting the checkbox at the
bottom of the Select Input screen
causes the “Edit Task” screen to be
displayed rather than the selected
input’s properties page. To edit an
Input’s properties, press the “Edit Input”
button on the Edit Task page.
Selecting an Input/Source (Battery)
All inputs (and outputs) have unique
settings based on their type. The scan
rate for this Task may be changed
here by pressing the top “Edit” button.
Advanced scanning options as well
as math and data options (e.g. slopes,
offsets, and custom functions) can be
added to the Task as well. A live reading
for most inputs is available above the
“OK” button.
When finished, press the “OK” button
to return to the “Edit Task” screen. The
Task is now configured to retrieve the
current value of the battery. To change
or edit the properties again for the
Task’s Input (Battery Voltage), press the
“Edit Input” button.
Note that only a single source may be
used as a Task’s Input (though multiple
outputs may be defined).