Xylem Cond 1970i - Manual (Page 36)

Operation Cond 1970i
36 ba75692e01 01/2007
4.5.3 Outputting the data storage
You can output the contents of the data storage:
z Stored data on the display
z Calibration data on the display
z Stored data on the serial interface
z Calibration protocol on the interface
Outputting stored data
on the display
You can perform the following activities:
1 Press the key repeatedly until StO dISP appears on the
display.
2 Press the key.
A measured value appears on the display.
The storage location of the data record is displayed for approx.
2 s, then the respective temperature appears.
Display further elements of the data record
(ID number, date, time, storage location) Press
Advance one data record (storage location) Press <
▲>
Go back one data record (storage location) Press <
▼>
REL1 Store Auto
Ident
I
pH
No.
Time
Cal
O
AR
cm 1/
Tref25
TP
ARng nLF
°
C
cm S/
Sal
%
S
%
m
mg/ l
Oxi
Year
Day.Month
Tref20
LoBat Lin
Sal
TEC
Baud
K /
REL2
pH / mV
o S T
S I D
RCL
P
Ident
Store
ARng
Sal
%
cm 1/
K / No.
REL1
Cal
S
0
%
m
mg/ l O
Oxi AR
Year
Day.Month
Tref20
LoBat Lin
Sal
pH
C
TEC
Auto
Time Baud
REL2
pH / mV
Tref25
3 5 5
cm S/
nLF
2 5 0
TP
°
C
RCL