YSI IQ S ENSOR N ET Field bus linking - Manual (Page 22)

Configuring the IQ S ENSOR N ET IQ S ENSOR N ET Field bus linking
20 ba76148e01 06/2013
Changing the
assignment of sensor
numbers
You want to change the assignment of sensor numbers to the sensors
in an already running IQ S
ENSOR N ET system.
Creating the identical
assignment of sensor
numbers in several
systems
You want to install several identical IQ S ENSOR N ET systems and, at
the same time, to create the same sequence of sensor number assign-
ments to the sensors in all systems.
1 Carry out a system start without any sensors (see system oper-
ating manual).
2 Connect the sensors to the system in the required order.
After connecting each sensor, wait until the sensor is recog-
nized by the system (see system operating manual, chapter
Installation).
1 Unplug all sensors from the IQ S ENSOR N ET .
When the inactive datasets are deleted, all settings for the
sensors are deleted as well.
2 Delete all inactive datasets in the list of sensors (see System
operating manual, chapter Deleting inactive datasets of sen-
sors).
3 Connect the sensors to the system in the required order.
After connecting a sensor, wait until the sensor is recognized
by the system (see system operating manual, chapter Installa-
tion).
1 Copy the configuration to a further controller from the original
one (see IQS Connect: ConfigSaveLoad).