Xylem 19-001-350R2 PACE Integrated Pump Controller Human Machine Interface (HMI) for the Silent Storm VFD Pumping System – Technician Guide User Manual
Page 18
18
Figure 40: Security Setup
SYSTEM SETUP
Tap [System Setup] from the Setup Menu.
A statement will appear warning you that changing
system settings could affect the functionality of the
entire system. You must accept this to proceed.
You can navigate the status screens for each
device that has been set up by tapping [Previous]
or [Next].
NOTE: The screens described below will only be
displayed if they are applicable to the current
system.
Job Information
Enter the job information such as ‘Job Number’,
‘Job Name’, ‘Main PLC IP (usually 192.168.1.10),
and ‘Phone Number’. Notice that the fields ‘HMI
Version’ and ‘PLC Version’ have been grayed out,
and are not editable.
Tap [Next] to move to the next System Setup
screen.
Figure 41: Job Information
Basic Pump Information
The number of pumps can be selected from a drop
down menu. Each pump can be assigned a name in
the editable fields at the bottom of the screen.
Tap [Next] to move to the next System Setup
screen.
Figure 42: Basic Pump Information
Zone Configuration
The number of flow zones is adjusted here. Up to
7 zones can be selected. This controls how many
flow totalizers are operable. Each flow zone will
keep track of water usage by day, week, month
and year (5 years).
Figure 43: Zone Configuration
The name of the flow zone is set here. Also, the
flow channel that is totalized for each zone is
configured here. These channels match the flow
channels from calibration. In addition to picking a
single channel for a particular zone, multiple
channels can be added together to form a single
flow zone by selcting more than one “Zone” to
totalize. Well pump flows can also be selected for
flow zones and even added to irrigation channels as
required. Flow zones can also be subtracted from
the total by selecting a “Subtract Flows” channel.
This may be required when a meter reads flows
going to more than one zone, and one of these
subsequent zones is metered separately.
Flow filtering is setup here as well. By selecting
“Disable Flow Reading if No Pump Running” for a
channel, that flow reading will be zero’ out when no
pump is running. This is in case the system picks