C2G 29505 WIRELESS DIGITAL SIGNAGE DISTRIBUTION SYSTEM - Manual (Page 21)

20
W
IRELESS LAN S ETTINGS
To use the wireless LAN, select Enable at Wireless Interface and configure the wireless
settings such as Wireless Mode, SSID and WEP according to the wireless network which
this product will be connected to.
1. Click Configuration – Basic in the left pane.
2. In the page displayed, configure the settings at Wireless Configuration, WEP
Configuration
and WPA Configuration.
TIP
• Be sure to set a WEP when you connect this product to a wireless LAN network.
• In the IEEE 802.11g band, it may be difficult to obtain enough communication bands for video
distribution, because the network devices supporting this band are used often now and many of the
communication bands are already used by someone. It is recommended to use IEEE 802.11a to
make a wireless communication via this product. The communication band can be specified at
Channel of the WDSDS Transmitter.
• When you use this product outside, be sure to comply with the radio regulations in the country.
Wireless channels or communication mode that can be used outside will differ depending on each
country.
The following are the sample settings to use this product in ADHoc mode.
S
AVE THE S ETTINGS
When finished to enter the settings, click Submit button in the left pane to save the
settings.
3.3 P
RODUCT
C
ONFIGURATION