Armasight TFT263BN0BHSXRP FLIR BHS-XR Command 640x480 Thermal Bi-ocular, no lens 30Hz, PAL - Manual (Page 28)

3—Operating Your Camera BHS-Series Bi-Ocular Operator’s Manual
22 March 2012
3–9 Auto-Standby Operation
Auto-Standby is a feature of the BHS-Series Bi-Ocular camera that
helps to guard against draining the batteries prematurely by
inadvertently leaving the camera on. Auto-Standby puts the camera
into the Standby state if the following three conditions are met:
• The camera is in the On state.
• The Auto-Standby switch (STBY) is set to ON.
• No buttons have been pressed for three minutes.
Once these conditions are met you will
see the following message in the display
and the camera will enter the Standby
state after the countdown is finished:
Press any button during this countdown to terminate Auto-Standby
and resume normal operation.
Note
Auto-Standby Switch
Unattended operation of the camera
requires disabling Auto-Standby.
Select OFF to turn off Auto-Standby.
Select ON to turn on Auto-Standby.
If Auto-Standby
is off, a reminder message will appear in the
display each time the camera enters the On state.
Pressing any button during an Auto-Standby countdown will only
terminate the countdown and abort the Auto-Standby.
The normal function of the button will not occur.
431-BHS0-01-10 BHS-Series Operators Manual.book Page 22 Friday, April 6, 2012 1:16 PM