Armasight TFT263BN0BHSXRP FLIR BHS-XR Command 640x480 Thermal Bi-ocular, no lens 30Hz, PAL - Manual (Page 18)

3—Operating Your Camera BHS-Series Bi-Ocular Operator’s Manual
12 March 2012
3–4 Charging the Camera
The batteries in the camera must be fully charged prior to use. If not
fully charged or if the recommended batteries are not installed, the
battery status indicator may not accurately reflect the remaining
battery life.
1. Connect the Hot Shoe to your camera.
2. Plug the power adapter provided with the camera into its power
source and also into the Hot Shoe.
3. Ensure that the plug is fully
seated in the Hot Shoe.
When charging correctly, the
charging indicator will be lit
yellow and will blink green for
one second within about 35
seconds.
The charging indicator will
continue to blink at decreasing
intervals until the batteries are
fully charged.
When fully charged, the
charging indicator will be lit
solid green. The initial charge
time is approximately 4 hours.
Note
The charging indicator will be lit solid green when the Hot Shoe is
not connected to the camera or the recommended batteries are
not installed. Ensure the batteries are charging by verifying the
green blinking indicator described above.
Plug from
Charging
indicator
Solid
green
power adapter
431-BHS0-01-10 BHS-Series Operators Manual.book Page 12 Friday, April 6, 2012 1:16 PM