Asus P/I-P65UP8/CP6ND - Manual (Page 28)

28 ASUS P/I-P65UP8 User’s Manual
III. INSTALLATION
(Connectors)
III. INST
ALLA
TION
9. IrDA-compliant Infrared Module Connector (5-pin IR)
This connector supports the optional wireless transmitting and receiving infra-
red module. This module mounts to a small opening on system cases that sup-
port this feature. You must also configure the setting through BIOS setup in
Chipset Features to select whether UART2 is directed for use with COM2 or
IrDA. Use the five pins (as defined by Intel) as shown below (Back View) and
connect a ribbon cable from the module to the baseboard according to the pin
definitions. The ribbon cable that may be supplied may either have five or ten
pins (for other standards). If using a ten-pin ribbon cable, use only the top five
row of the ribbon cable plug.
Infrared Module Connector
For the infrared feature to be available, connect an
infrared module (optional) to the baseboard.
+5V IRTX
IRRX
NC GND
Back View Front View
IRRX
+5V
IRTX
NC
GND
R
10. USB Module Connector (10-1 pin USB)
If you want to use the universal serial bus (USB), you need to purchase an exter-
nal connector set. The external connector connects to the 9-pin block.
R
USB Module Connector
1: USB +5Volt
3: USB Port 1 –
5: USB Port 1 +
7: Ground
9: (no connection) 2: USB +5Volt
4: USB Port 0 –
6: USB Port 0 +
8: Ground
10: (no connection)
1
9 10
2