Asus P/I-P65UP8/CP6ND - Manual (Page 27)

ASUS P/I-P65UP8 User’s Manual 27
III. INSTALLATION
(Connectors)
III. INST
ALLA
TION
7. VGA Connector (16 pin VGACON)
To use the onboard VGA, you must attach the provided VGA cable to this con-
nector and mount the bracket to the system cabinet on a free expansion slot or
remove the bracket and mount to the system cabinet’s serial port opening. The
VGA cable then provides a standard 15-pin D-Sub connector for a monitor.
R
2
16 15
1
VGA (Monitor) Connector
Bracket to end approximately 6inch
Orient the red stripe on the
monitor cable with pin 1
TIP: You may also remove the bracket
connectors and mount them directly to
the case to save expansion slot space.
8. VGA Memory Upgrade Sockets
This baseboard comes with 1MB VGA memory. Two sockets are provided to
upgrade the VGA memory to 2MB by adding two EDO DRAM’s.
R
VGA Memory Sockets
Small indentation on
the chip’s sloped edge Socket's cut corner
Each chip is 512KB DRAM. Two chips must be
installed to increase the VGA memory by 1MB.
NOTE: The indentations are shown white for visibility, they are normally black.
Match the small indentation on the chip’s sloped edge with the socket’s cut corner.
Place the chip flat and evenly into the socket and press firmly but carefully so that
the chip enters evenly. When installed, the chip should be flush with the socket.