Asus K8N-E Deluxe - Manual (Page 45)

ASUS K8N-E Deluxe motherboard 2-23
K8V-E
®
K8N-E SATA RAID Connectors
GND
RSA
T A_TXP2
RSA
T A_TXN2
GND
RSA
T
A_RXP2
RSA
T A_RXN2
GND
GND
RSA
T A_TXP1
RSA
T
A_TXN1
GND
RSA
T A_RXP1
RSA
T A_RXN1
GND
SATA_RAID2
SATA_RAID1
GND
RSA
T A_TXP2
RSA
T A_TXN2
GND
RSA
T
A_RXP2
RSA
T A_RXN2
GND
GND
RSA
T A_TXP1
RSA
T
A_TXN1
GND
RSA
T A_RXP1
RSA
T A_RXN1
GND
SATA_RAID4
SATA_RAID3
4. RAID Serial ATA connectors
(7-pin SATA_RAID1, SATA_RAID2, SATA_RAID3, SATA_RAID4)
These Serial ATA connectors support SATA hard disks that you can
configure as a RAID set. Through the onboard Silicon Image
SATALink™ Sil 3114 RAID controller, you can create a RAID 0, RAID
1, RAID 10, JBOD or RAID 5 configuration. See Chapter 5 for details
on RAID configuration.
• To create a RAID set, make sure that you have installed the Serial
ATA devices and connected the Serial ATA cables. You cannot
enter the Silicon Image RAID utility during POST if you did not
install any Serial ATA device.
• The SATALink™ RAID 5 and JBOD configuration can be set using
the SATALink™ SATA RAID Management Software only. See
section “5.5.3 Silicon Image RAID configurations” for details.
• Refer to section “5.6.3 Silicon Image RAID Configurations” for
details on SATA RAID configuration.