Asus K8N-E Deluxe - Manual (Page 44)

2-22 Chapter 2: Hardware information
3. Serial ATA connectors (7-pin SATA1, SATA2)
These connectors support the thin Serial ATA cables for primary
internal storage devices. The current Serial ATA interface allows up to
150 MB/s data transfer rate, faster than the standard parallel ATA with
133 MB/s (UltraDMA133).
You can configure a RAID 0, RAID 1, RAID 0+1, or JBOD set together
with the Primary IDE connector.
K8V-E
®
K8N-E SATA Connectors
SATA1
GND
RSA
T
A_TXP1
RSA
T A_TXN1
GND
RSA
T A_RXN1
RSA
T A_RXP1
GND
SATA2
GND
RSA
T
A_TXP2
RSA
T A_TXN2
GND
RSA
T A_RXN2
RSA
T A_RXP2
GND
Important notes on Serial ATA solution:
• The Serial ATA cable is smaller and more flexible, allowing easier
routing inside the chassis. The lower pin count of the Serial ATA
cable eliminates the problem caused by the wide, flat ribbon cables
of the Parallel ATA interface.
• Hot plug support for Serial ATA drive and connections is not
available on this motherboard.
• Install Windows ® XP Service Pack 1 when using Serial ATA drives.
• Refer to section “5.6.2 NVIDIA ® RAID configurations” for details on
SATA RAID configuration.