� ahci configuration, Ahci cd/dvd boot time out [15 – Asus Maximus II Gene User Manual
Page 95

ROG Maximus II GENE
3-21
SATA Port1–6 [Auto]
[Auto]
Allows automatic selection of the device type connected to
the system.
[Not Installed] Select this option if no SATA devices are installed.
SMART Monitoring [Enabled]
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitor
system. When read/write of your hard disk errors occur, this feature allows
the hard disk to report warning messages during the POST.
[Enabled]
Enable the SMART monitoring feature.
[Disabled]
Disable the SMART monitoring feature.
3.4.�
AHCI Configuration
This menu is for AHCI configuration. It appears only when you set the Configure
SATA as item under SATA Configuration to [AHCI].
AHCI CD/DVD Boot Time out [15]
Selects the boot time out value for SATA CD/DVD devices in AHCI mode from the
following options: [0] [5] [10] [15] [20] [25] [30] [35]
AHCI Port1–6 [XXXX]
Displays the status of auto-detection of SATA devices.
BIOS SETUP UTILITY
Main
AHCI Settings
AHCI CD/DVD Boot Time out
[15]
AHCI Port1 [Not Detected]
AHCI Port2 [Not Detected]
AHCI Port3 [Not Detected]
AHCI Port4 [Not Detected]
AHCI Port5 [Not Detected]
AHCI Port6 [Not Detected]
Some SATA CD/DVD in
AHCI mode need to
wait ready longer.
BIOS SETUP UTILITY
Main
SATA Port1
Device :Not Detected
SATA Port1
[Auto]
SMART Monitoring
[Enabled]
Select the type of
devices connected to
the system.