Asus Maximus III Gene - Manual (Page 91)

ROG Maximus III GENE 3-21
3.4.4 SATA 1–6
While entering Setup, the BIOS automatically detects the presence of Serial ATA
devices. There is a separate sub-menu for each SATA device. Select a device item
then press to display the SATA device information.
The BIOS automatically detects the values opposite the dimmed items (Device,
�endor, Size, �BA Mode, Block Mode, PIO Mode, Async DMA, Ultra DMA, and
SMART monitoring). These values are not user-configurable. These items show
[Auto] if no SATA device is installed in the system.
Type [Auto]
Allows you to select the type of SATA drive installed.
[Not Installed] Select this option if no SATA drive is installed.
[Auto]
Allows automatic selection of the appropriate SATA device type.
[CDROM] Select this option if you are specifically configuring a CD-ROM
drive.
[ARMD] Select [ARMD] (ATAPI Removable Media Device) if your device is
either a ZIP, LS-120, or MO drive.
LBA/Large Mode [Auto]
Enables or disables the LBA (Logical Block Addressing) mode.
[Auto]
Select [Auto] to enable the LBA mode (Logical Block Addressing
mode) if the device supports this mode, and if the device was not
previously formatted with LBA mode disabled.
[Disabled] Disable this function.
v02.61 (C)Copyright 1985-2009, American Megatrends, Inc.
BIOS SETUP UTILITY
Main
Select the type
of device connected
to the system.
←→ Select Screen
↑↓ Select Item
+- Change Field
F1 General Help
F10 Save and Exit
ESC Exit
SATA 1
Device :Hard Disk
Vendor :HDT722516DLA380
Size :164.7GB
LBA Mode :Supported
Block Mode:16Sectors
PIO Mode :4
Async DMA :MultiWord DMA-2
Ultra DMA :Ultra DMA-5
SMART Monitoring:Supported
Type [Auto]
LBA/Large Mode [Auto]
Block(Multi-Sector Transfer)M [Auto]
PIO Mode [Auto]
DMA Mode [Auto]
SMART Monitoring [Auto]
32Bit Data Transfer [Enabled]