Asus Maximus III Gene User Manual

Page 57

2. JMicron

JMB363 Serial ATA connectors (7-pin SATA_E1 [black])

This connectors is for the Serial ATA signal cables for Serial ATA optical disk

drives.

To enable hot-plugging, set the J-Micron Controller item in the BIOS setting to

[AHCI Mode], and then reboot the system. See section 3.5.3 Onboard Device

Configuration for details.

3. USB connectors (10-1 pin USB910; USB1112; USB13)

These connectors are for USB 2.0 ports. Connect the USB module cable

to any of these connectors, then install the module to a slot opening at the

back of the system chassis. These USB connectors comply with USB 2.0

specification that supports up to 48� Mbps connection speed.

Never connect a 1394 cable to the USB connectors. Doing so will damage the

motherboard!

You can connect the USB cable to ASUS �-Connector (USB, blue) first, and

then install the Q-Connector (USB) to the USB connector onboard.

The USB module cable is purchased separately.

ROG Maximus III GENE

2-31