Asus M4N82 Deluxe - Manual (Page 31)

ASUS M4N82 Deluxe 2-11
Chapter 2
2.4.2 Memory configurations
You may install 512MB, 1GB, 2GB and 4GB unbuffered ECC and non-ECC DDR2 DIMMs
into the DIMM sockets.
• You may install varying memory sizes in Channel A and Channel B. The system maps
the total size of the lower-sized channel for the dual-channel configuration. Any excess
memory from the higher-sized channel is then mapped for single-channel operation.
• Due to CPU limitation, DDR2 1066 MHz is supported by AM3/AM2+ CPU for one
DIMM per channel only. For system stability, when four DIMMs are installed, all DIMMs
run at DDR2 800 MHz as the default setting.
• We recommend that you install the memory modules from the yellow slots for better
overclocking capability.
• Always install DIMMs with the same CAS latency. For optimum compatibility, it is
recommended that you obtain memory modules from the same vendor.
• Due to the memory address limitation on 32-bit Windows OS, when you install 4GB
or more memory on the motherboard, the actual usable memory for the OS can be
about 3GB or less. For effective use of memory, we recommend that you do any of the
following:
- Use a maximum of 3GB system memory if you are using a 32-bit Windows OS.
- Install a 64-bit Windows OS when you want to install 4GB or more on the
motherboard.
• This motherboard does not support DIMMs made up of 256 megabit (Mb) chips or
less.
• The default memory operation frequency is dependent on its Serial Presence Detect
(SPD), which is the standard way of accessing information from a memory module.
Under the default state, some memory modules for overclocking may operate at a
lower frequency than the vendor-marked value. To operate at the vendor-marked or at
a higher frequency, see section 3.6 Advanced menu for manual memory frequency
adjustment.
• For system stability, use a more efficient memory cooling system to support a full
memory load (4 DIMMs) or overclocking condition.
Vendor Part No. Size
SS/
DS
Chip
Brand Chip NO.
Timing
DIMM (BIOS)
Voltage
DIMM socket
support (Optional)
A*
B*
OCZ OCZ2FX12002GK 2GB (Kit of 2) DS N/A Heat-Sink Package 5-5-5
(667-5-5-5-15) 2.1
• •
M4N82 Deluxe Motherboard Qualified Vendors Lists (QVL)
DDR2-1200 MHz capability