Asus M2N-VM SE - Manual (Page 41)

ASUS M2N-VM SE 1-29
4.. Chassis.intrusion.connector.(4-1.pin.CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
R
M2N-VM SE
5.. MP3-In.connector.(4-pin.MP3IN.[red])
This connector is for the MP3-In module that allows you to connect your
MP3 player to the speakers of the computer. For more information, refer to
the MP3-In Module Quick Installation Guide or the ASUS FrontLinker™ user
guide.
• The MP3-In module is bundled with the motherboard package if the
motherboard does not include the ASUS FrontLinker™. Connect the cable
to the MP3IN connector, and enjoy music from computer speakers even
when the PC is turned off.
• Do not plug the MP3-In cable into the Audio-In connector.
R
M2N-VM SE