Asus M2N-VM SE - Manual (Page 40)

1-28 Chapter 1: Product introduction
3.. IDE.connectors.(40-1.pin.PRI_IDE)
The onboard IDE connector is for Ultra DMA 133/100/66 signal cable(s).
There are three connectors on each Ultra DMA 133/100/66 signal cable: blue,
black, and gray. Connect the blue connector to the motherboard’s IDE
connector, then select one of the following modes to configure your device(s).
• Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as “Cable-Select,” make sure all other device
jumpers have the same setting.
R
PIN1
M2N-VM SE
Drive.jumper. Mode.. Cable.. .
. setting.. of.device(s). connector
Single device Cable-Select or Master - Black
Two devices Cable-Select Master Black
Slave Gray
Master Master
Slave Slave
Black or gray