Asus P5Q PRO - Manual (Page 53)

ASUS P5Q PRO 2-27
3. ICH10R Serial ATA connectors (7-pin SATA1-6 [red])
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID
1, RAID 5, RAID 10 configuration with the Intel ® Matrix Storage Technology
through the onboard Intel ® ICH10R RAID controller.
Connect the right-angle side of SATA
signal cable to SATA device. Or you
may connect the right-angle side of
SATA cable to the onboard SATA port
to avoid mechanical conflict with huge
graphics cards.
right angle side
• These connectors are set to Standard IDE mode by default. In Standard
IDE mode, you can connect Serial ATA boot/data hard disk drives to these
connectors. If you intend to create a Serial ATA RAID set using these
connectors, set the Configure SATA as item in the BIOS to [RAID]. See
section 3.3.6 Storage Configuration for details.
• Before creating a RAID set, refer to section 4.4.3 Intel RAID
configurations or the manual bundled in the motherboard support DVD.
• You must install the Windows ® XP Service Pack 1 before using Serial ATA
hard disk drives. The Serial ATA RAID feature (RAID 0, 1, 5, and 10) is
available only if you are using Windows ® XP or later version.
• When using hot-plug and NCQ, set the Configure SATA as in the BIOS to
[AHCI]. See section 3.3.6 Storage Configuration for details.